[. . . ] €¯2) 2 Fill the water tank up to the MAX indication (Fig. Selecting temperature and steam setting Table 1 Calc-Clean function IMPORTANT:To prolong the lifetime of your appliance and to maintain good steaming performance, use the Calc-Clean function once every two weeks. When flakes come out of the soleplate during ironing), use the Calc-Clean function more frequently. [. . . ] Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. €¯If you are unable to solve the problem with the information below, visit www. Solution Set an ironing temperature that is suitable for steam ironing. Temperature setting MAX 3 2 1 1 Steam setting ;, ;, ECO t t Steam boost Yes Yes No No No Spray Yes  Yes Yes No No You have put an additive in the water tank. The steam boost function does not work properly (water leaks out of the soleplate). You have used the steam boost function too often within a very short period. Water drips from the soleplate after the iron has cooled down or has been stored. When I push the steam control to the turbo steam position, the steam control jumps back. You have put the iron in horizontal position while there was still water in the water tank. Wait a while before you use the steam boost function again. The temperature light goes on to indicate that the iron is heating up (Fig. 3 When the temperature light goes out, the iron has reached the correct temperature. 4 Consult table 1 to select a steam setting that corresponds to the temperature you have set (Fig. Note:To use turbo steam , keep the steam control pressed to the turbo steam position continuously. [. . . ] €¯2) Cleaning and maintenance Cleaning 1 Set the steam control to t (dry ironing), unplug the iron and let it cool down. €¯2) 2 Pour any remaining water out of the water tank. 3 Wipe flakes and any other deposits off the soleplate with a damp cloth and a non-abrasive (liquid) cleaning agent. [. . . ]